Veery-0E Satellite

Veery-0E
Veery-0E
Name VEERY-0E “Ectobius” (Fledgling Veery, Veery v0.3-rc0)
Form factor CubeSat
Units or mass 1U
Status Operational? (Website reports it as operational but object not identified as of 2024-05-26)
Launched 2024-03-04
NORAD ID ?
Deployer EXOpod Nova 12U/16U [Exolaunch]
Launcher Falcon 9 (Transporter-10)
Entity name Care Weather
Institution Company
Entity type Commercial
Nation US
Oneliner

Building phone—sized weather satellites to power a super accurate forecast.

Description

Conduct on-orbit testing of custom satellite bus subsystems, which are crucial for the success of its future nanosatellite scatterometer, "Veery." The tests to be conducted during the mission include fully Earth-pointing control, radio data rate stress testing, and validation of the enhanced attitude determination and control system.

Veery v0.3 will test some cool tech!

Moreover, the mission will feature the first orbital testing of Care Weather’s high-voltage radar power system, paving the way for future radar testing. 

The communications subsystem includes an Iridium 9603 satellite modem with a body-mounted patch antenna (not deployed), as well as an amateur radio payload, which will be discussed in more detail below, with deployed dipole antenna.

The deployment mechanism subsystem has been updated with an electro-permanent magnet deployment system, replacing the servo-driven latch of Veery-FS1 for improved reliability. The attitude determination subsystem now features fine sun-sensors, an inertial measurement unit, and a magnetometer. The attitude control subsystem incorporates improvements for greater reliability in the 3-axis reaction wheels and magnetorquers

The amateur payload will also be used for transmitting thermal data from the satellite. This data will be used by faculty and students at Brigham Young University in the planning of future cubesat missions. This data will be freely accessible. The amateur payload will be used to transmit the following data Temperature Sensors 6 solar panel on each face of CubeSat near radar power-amplifier to measure radar waste heat 5 on the power board, 4 near batteries 1 by amateur radio power amplifier Attitude determination telemetry - for determining satellite orientation relative to the sun and the Earth to calculate illumination from the sun, Sun sensors Magnetometer Gyro Position determination telemetry (GPS) - for determining satellite beta angle Power telemetry - to calculate bottoms-up, general waste heat from power consumption Battery voltage and current - as a top-level verification of power loads and the resulting energy dissipation within the satellite. Solar power by panel - to subtract from 8 Amateur Satellite Frequency Coordination Request v40 Page incident heat for Earth albedo and solar calculations. The amateur payload will not be used to transmit radar measurement data, because this data has no relevance to the cubesat thermal investigation. However, the above temperature and telemetry data will be collected during radar operation to evaluate the impact of this heat generation source on thermal conditions. These data will be collected while the host spacecraft undergoes different operating scenarios with a variety of thermal characteristics: Minimum operations - No ADCS, safe-mode with Iridium operated Typical operation - ADCS on Communications - ADCS and amateur radio on High-heat operation - ADCS and radar on The purpose of this mission is to give students at Brigham Young University the opportunity to build and test satellite ground stations, and operate an amateur satellite. The mission will transmit cubesat thermal data that will inform future BYU cubesat projects, as well as operate a digipeater and digital mailbox for the amateur community to use. This mission will also give other amateurs throughout the world the opportunity to make contact with an orbiting satellite, and receive the thermal data listed above. As a payload operated by Brigham Young University and hosted on an experimental Care Weather satellite, this mission will provide an additional opportunity for amateur radio operators around the world to make contact with an orbiting satellite, and receive thermal telemetry data. As part of this project, students at Brigham Young University will be maintaining and operating a satellite ground station. This station will include receivers that will be connected to the SatNOGS network, making them available for others to use. The purpose of this mission is to give students at Brigham Young University the opportunity to build and test satellite ground stations, and operate an amateur satellite. The mission will transmit cubesat thermal data that will inform future BYU cubesat projects, as well as operate a digipeater and digital mailbox for the amateur community to use. This mission will also give other amateurs throughout the world the opportunity to make contact with an orbiting satellite, and receive the thermal data listed above.

Sources [1] [2] [3] [4]
Photo sources [1] [2]
Keywords Globalstar or Iridium or Inmarsat
On the same launch

Last modified: 2024-05-29

Feel free to connect at any time.

Created by Erik Kulu

Email: erik.kulu@nanosats.eu
LinkedIn: linkedin.com/in/erikkulu

Social Platforms

LinkedIn: Nanosats
Twitter: @nanosatellites

Sister Websites

NewSpace Index: newspace.im
Factories in Space: factoriesinspace.com

Copyright © 2014 - 2024 Erik Kulu